S15-M Type Oil-Immersed Amorphous Alloy Distribution Transformer

Here's detailed information about company's product "S15-M Type Oil-Immersed Amorphous Alloy Distribution Transformer". You're welcome to contact us if you have any doubts.

                                                                           email: sales@zjyb-electric.com     tel: +86-577-62566535

General introduction of S15-M Type Oil-Immersed Amorphous Alloy Distribution Transformer

S15 transformer is in development at S9 series transformer.It is in low loss, low noise, capable of short-circuit, good impact resistance and Well-run performance.
It applies new type insulation structure and improves the ability of short-circuit resistance.The iron core is made of high-quality cold-rolled silicon-steel plate.High-voltage winding group is made of high quality copper wires and it adopts multilayer cylindrical structure.All fasteners have been processed with special treatment to prevent them from loosening.

Environmental conditions:

1.Type:Outdoor
2.Normal Service Conditions:
3.The height above the sea level is below 1000m;
4.Ambient temperature: Highest air temperature+40 ℃, Lowest air temperature-25℃
5.Relative air humidity:≤90%(+25℃)
6.installation site: no corrosion gas, No obvious dirt
For Agricultural power distribution and lighting

Transformer Standard:

GB1094.1~2-1996 power transformer
GB1094.3,5-2003 power transformer
GB/T6451-2008 Three phase oil immersed power transformer

Model description of S15-M Type Oil-Immersed Amorphous Alloy Distribution Transformer: